You are here

FM4-176L-S6E2CC-ETH - Arm® Cortex®-M4 MCU Starter Kit with Ethernet and USB Host | Cypress Semiconductor

FM4-176L-S6E2CC-ETH - Arm® Cortex®-M4 MCU Starter Kit with Ethernet and USB Host

Last Updated: 
May 13, 2020

CY3295 Kit Image


The Arm® Cortex®-M4 MCU Starter Kit with Ethernet, USB and audio is a low-cost development platform for the Cypress 200MHz FM4 S6E2C-Series of Arm® Cortex® MCUs. The development kit enables rapid development of high-performance embedded systems using the Arduino Uno-compatible interface to connect Arduino shields for low-cost hardware expansion.

Featuring Arm® Cortex®-M4 FM4 S6E2C-Series MCU

  • 200MHz Arm® Cortex® MCU with DMA
  • 675 CoreMark® MCU
  • Single precision IEEE 754 compliant floating point unit
  • 2MB flash, 256KB SRAM and 190 GPIOs.
  • Communication interfaces: 10/100 Ethernet (IEEE 802.3),  USB host, USB device, CAN, LIN, High-Speed Quad SPI, I2S, I2C and UART.
CY3295 Kit Image

Featuring Arduino Uno Footprint with Onboard Sensors and CMSIS-DAP Interface

  • Arduino™ Uno compatible footprint
  • Onboard sensors: Accelerometer and Photo Transistor 
  • External peripherals: Stereo codec, SRAM, Serial flash and multi-color LEDs 
  • CMSIS-DAP interface: Programming and debugging of the S6E2CC MCU
CY3295 Kit Image

Kit Contents:

  • FM4 S6E2C-Series Board
  • USB Standard-A to Micro-B cable
  • Quick Start Guide


Code Examples

Use the Peripheral Driver Library (PDL) code examples. Download and install the PDL, and look in the examples folder. There are dozens of code examples available. Retarget the examples to your hardware.

You can also download a blank template project (S6E2CC series Template Project Version 1.0), which you can use as a starting point for your own development.