You are here

Using the CY7C68013 FX2 device, do the T0 through T2 input pins require pull up and pull down resistors, or can they be left floating? | Cypress Semiconductor

Support & Community

Using the CY7C68013 FX2 device, do the T0 through T2 input pins require pull up and pull down resistors, or can they be left floating?

Last Updated: April 08, 2011
Answer: 

Unused pins should not be left unconnected (or floating). Instead, they should be connect to Vcc or Gnd through a ~10K resistor. If there's no chance that an unused pin will ever be configured as an output, then it is safe to tie the pin directly to the appropriate voltage (Vcc or Gnd) without the resistor.

Please Note: Any unused inputs should be terminated to the appropriate voltage (ground or power).

Keywords: Unused, pin, T0, T2, timer, pull up, pull down, floating

Provide feedback on this article

Browse KB By Product

Browse KB by Type