You are here

USBUART is not detected when connected to the PC | Cypress Semiconductor

Support & Community

USBUART is not detected when connected to the PC

Last Updated: December 29, 2011

I use Hyperterminal to connect to an USBUART project. Sometimes, when I plug the USBUART project to the PC, it is not detected by Hyperterminal. When I disconnect and reconnect, it gets detected. What could be the problem?


This problem can occur in the following situation:

Let us say there is an active Hyper Terminal connection with the USB-UART, for example at port COM18.  The USBUART project is disconnected from the USB port without first disconnecting the connection in Hyperterminal.  Now, if the USBUART project is plugged into the same USB port, it will not be recognized. 

In order to avoid this situation, before  unplugging  the USBUART from the PC, disconnect the connection using the Disconnect button in Hyper terminal (the small icon with a telephone).  To connect it, plug in the USBUART to the PC, and connect using the Connect button in Hyper terminal.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type