You are here

Types of Burst Modes in Single Data Rate Synchronous SRAMs - KBA80733 | Cypress Semiconductor

Support & Community

Types of Burst Modes in Single Data Rate Synchronous SRAMs - KBA80733

Last Updated: June 26, 2012

What are the types and functions of burst modes in Standard Sync/NoBL SRAMs (single data rate synchronous SRAMs)?

Two Least Significant Bits of the address (A0 and A1) are fed to internal BURST Counter (Figure 1) A burst counter uses one of two methods to increment an address: linear or interleaved. For each address the user provides, the system generates 4 separate addresses inside the SRAM to access four locations. The result is a four-fold reduction of movement on address lines. Figure 1 illustrates how the two least significant bits of the address enter the internal Burst Counter. Mode and the advance input decide the mode of operation of the burst counter, and it generates lower two address bits accordingly.

Figure 1. SRAM Address Block


Linear Burst: The device operates in the linear mode when the user sets the Mode pin to LOW. The internal counter increases in a linear fashion from the present value with A1 and A0 as the LSBs.

Table 1. Linear Burst Mode


Interleaved Burst: The device operates in the interleaved mode when the user sets the Mode pin to HIGH. In Interleaved mode, the counter follows a pattern based on the initial value. The pattern is mainly to address Little Endian and Big Endian Byte orders. For our example in Table 2, we declare two pairs of memory locations: 00-01 & 10-11. The counter follows a pattern after each increment based on the lowest two bits of the initial value loaded into it. The counter first changes to the counterpart of the pair. For example, if the first value is 10, the next will be 11. If the first value is 11, the next will be 10. If the first value is 01, the next will be 00. After that, the counter accesses the values in the other pair in the same order as the first. So if in the first two accesses, the sequence is from higher to lower (e.g. 11 to 10), the next will be 01 to 00 and vice versa.

Table 2. Interleaved Burst Mode


For general operation, one burst method does not have any significant advantage over the other. Different processors support different types of burst operation. While the Intel processors support the interleaved burst mode, The power PC microprocessors support the linear burst mode.

Provide feedback on this article

Browse KB By Product

Browse KB by Type