You are here

Setting the parameters for the PLT user module | Cypress Semiconductor

Support & Community

Setting the parameters for the PLT user module

Last Updated: December 05, 2011

How do I set the parameters in the PLT user module?


There are three ways to set the parameters of the PLT user module:

1)   Properties Window: In the chip view, the parameters can be modified individually in the properties window. This is the traditional way of statically setting the parameter values prior to run-time. However, when there are many parameters (e.g. when “FSK Modem + Network” user module option is selected), this is the slowest method of setting the parameters.




2)   PLC Config Wizard: Right-click on the PLT_1 user module instance and select “PLC Config Wizard”. This will open the wizard, which allows the user to quickly set all of     the parameters prior to run-time. However, this method cannot be used for changing the parameters at run-time.




3)   PLT_Memory_Array variable: In the application code, the parameters can be set by writing to the PLT_Memory_Array variable. The constants for the address offset and bit names are listed in plt.h.  The bit mapping and description of each of the parameters in the PLT_Memory_Array can be found in the data sheet. This method has the advantage of being able to modify the parameters at run-time. Note: For the “FSK Modem Only” user module option, only register offsets 0x30 through 0x34 and 0x6A through 0x72 are available.




Provide feedback on this article

Browse KB By Product

Browse KB by Type