You are here

SET FEATURE command Issued from AT2LP | Cypress Semiconductor

Support & Community

SET FEATURE command Issued from AT2LP

Last Updated: June 23, 2011

What causes a SET FEATURE command to be issued from AT2LP immediately after power on ? Can this be prevented using an EEPROM setting?


During drive initialization, after resetting the drive, if the drive supports UDMA mode, then the transfer mode is set to UDMA. Else, the highest PIO mode is enabled. Enabling the correct mode is done by the following procedure.

First of all, the Sector Count register is written with the 'transfer mode' which has to be set. Then 0x03 is written to the Feature register to indicate that this is a 'set tansfer mode' command. Finally, the command register is written with the 'set feature' command which causes the execution of the command.

The AT2LP is a fixed-function part, so there is no software or firmware that can be rewritten to change the behavior of the chip.

Provide feedback on this article

Browse KB By Product

Browse KB by Type