You are here

PSoC programmer - Reset Programming mode | Cypress Semiconductor

Support & Community

PSoC programmer - Reset Programming mode

Last Updated: March 27, 2010

Question: Is there a need to reset or power cycle the PSoC after programming in “Reset Mode” using MiniProg and PSoC Programmer software?

Response: In earlier versions of PSoC Programmer, the user had to reset the system after programming in Reset mode. From PSoC programmer 3.10 and above, the software sends a Reset signal at the end of programming.  So there is no need for power cycling or resetting the PSoC after the programming completes.

Provide feedback on this article

Browse KB By Product

Browse KB by Type