You are here

Programming EncoreII devices In System Using USB interface | Cypress Semiconductor

Support & Community

Programming EncoreII devices In System Using USB interface

Last Updated: May 30, 2011

How do I program the EncoreII devices In System using USB cable? What hardware do I need and what is the procedure?


The EncoreII devices may be programmed using MiniProg and an ISSP to USB adapter board. 

Details of the hardware connection and programming procedure may be found in the attached document "Updating Firmware in an enCoRe II Based Device" for the connection.

Also refer to the attachment "ENCOREII_5-Pin to USB Programming Adapter_schematic" below for the connection details of the 5-pin connector to USB adapter that is used to connect the Encore part to the CY3217-MiniProg1.

File TitleLanguageFile SizeLast Updated
Download Programming Encore devicesEnglish545.63 KB11/25/09
Download Programming Encore devicesEnglish13.06 KB11/25/09
Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type