You are here

Programming the CY22150 with FPGA | Cypress Semiconductor

Support & Community

Programming the CY22150 with FPGA

Last Updated: March 14, 2014

When using an FPGA on a PCB for serial programming of the CY22150, during write mode, the device will respond with an ACK pulse after eight bits by pulling the SDAT line low. Is this a 'weak 0', or a 'strong 0'? Can there be a conflict with the I/O of the FPGA?


When the  CY22150 sends an ACK, it is a strong zero.

Provide feedback on this article

Browse KB By Product

Browse KB by Type