You are here

Plugging Devices into a Hubs Downstream Ports | Cypress

Support & Community

Plugging Devices into a Hubs Downstream Ports

Last Updated: September 16, 2011

Why do we get error messages when plugging a device into one of the hubs downstream ports? For example, when we connect a USB keyboard that need 400 mA power , we see the following error message in Windows: "The hub does not have enough power available to operate the USB Composite device".


USB devices have two power ratings, low power 100mA or less, and high power, >100mA (500mA).Each port coming out of the root hub of your PC supplies 500mA. When you connect a bus-powered hub, the hub controller requires 100mA and each downstream port is supplied 100mA. Therefore you are only allowed to connect low power devices downstream of a bus-powered hub.To connect high power devices downstream of a hub, the hub must be self powered, not bus powered. This will allow each port of the hub to have 500mA. As well, when you connect a hub or USB composite device downstream of another hub, the first hub must be self-powered.


Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type