You are here

Message 'Could not connect to ICE' | Cypress Semiconductor

Support & Community

Message 'Could not connect to ICE'

Last Updated: June 09, 2011

When I try to run the drawusb project I get a "Could not connect to ICE" message. How do I resolve this?


The Project settings in the PSoC Designer tools default to having the ICE connected to LPT1.  To connect to the ICE via USB:

1.  Select Project from the top menu

2.  Select Settings

3.  Select the Debugger tab

4.  From the ICE connected to: drop down menu select USB/0413D324, then press OK. Note: USB/0413D324 reflects an unique ICE number, your actual number will differ from what is shown here.


Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type