You are here

LCD connections using 4 data lines | Cypress Semiconductor

Support & Community

LCD connections using 4 data lines

Last Updated: September 29, 2010

Question: In PSoC1 or PSoC3 can we use only 4 data lines to drive the LCD. Also, should these pins be connected consequently.

Answer: In PSoC Designer and Creator, the LCD APIs uses only 7 bits, the description is as below:-

4 for data lines (D4-D7)

1 for Enable.

1 for Register Select (RS)

1 for Read/Write (RW)

D0-D3 lines of LCD should be grounded.

These pins must be connected consequently on a single port.

i.e. on a single port,  first 4 pins should be data lines, 5th pin as Enable, 6th as Register Select and 7th as Read/Write



Provide feedback on this article

Browse KB By Product

Browse KB by Type