You are here

How is CFI information read? - KBA203661 | Cypress Semiconductor

Support & Community

How is CFI information read? - KBA203661

Last Updated: October 11, 2015

How is CFI information read? 


To read CFI information on Cypress Flash memory, you must put the device into CFI query mode. The device enters the CFI query mode when the system writes the CFI Query command, 98h, to address 55h, any time the device is in read mode or autoselect mode. Once in CFI query mode, you can read CFI information from the addresses (see the device data sheet). To terminate CFI query mode, the system must write the reset command.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type