You are here

EZ-USB FX2 Firmware Debugging Issue | Cypress Semiconductor

Support & Community

EZ-USB FX2 Firmware Debugging Issue

Last Updated: April 02, 2011

After downloading the mon-int-sio1.hex or mon-int-sio0.hex to the EZ-USB FX2LP board, when debugging is started from Keil,the debugger pops up with "target board not found." What can be the reason for this?


The first thing to check is the memory allocation of your firmware. The default internal monitor is loaded from 0x0000-0x1075. When downloading firmware, make sure the code is not trampling over the monitor code. The document README.txt from location C:\Cypress\USB\Target\Monitor(once you have downloaded and installed CY3684)  contains information regarding the memory placement of each of the monitor files. 

The application note Setting Up, Using, and Troubleshooting the Keil(TM) Debugger Environment - AN42499 lists a number of other factors you can check to troubleshoot the debugger.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type