You are here

E2PROM Parameters and Map File | Cypress Semiconductor

Support & Community

E2PROM Parameters and Map File

Last Updated: March 27, 2011

How does the locations of EEPROM User Module reflect in the Map file?


The Map file (.mp) contains details about Flash and RAM usage, address of RAM and ROM areas, size of areas, location of labels in Flash, address of RAM variables etc.  This file may be found in the "output" folder in the project directory. 

The E2PROM area will be shown in the map file as per the "First Block" and "Length" parameters set in the E2PROM user module.  For example if the First block is set to 131 and length to 70, the E2PROM area will start at 0x20C0 (hex of 131 * 64) and end at 0x2106 (hex of (131 * 64) + 70)

Provide feedback on this article

Browse KB By Product

Browse KB by Type