You are here

Drive mode for maximum driving strength | Cypress Semiconductor

Support & Community

Drive mode for maximum driving strength

Last Updated: March 27, 2011

Which drive mode should be used for providing the best possible drive strength? Is it possible to tie multiple lines together in order to drive higher load?


The best way to get the maximum drive strength is using Strong mode, where it can source as well as sink current. The limit of source is 10mA and limit of sink is 25mA. On the other hand, if only the sink mode is required, then the line can also be configured as pull up, and if only sourcing is required, then the drive can be set as pull down.

Yes, it is possible to increase the drive power by connecting multiple GPIO pins. In this case, the levels written to these pins must be same.  Use low value series resistors on each pin so that proper current sharing between the pins takes place.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type