You are here

Default TT Mode of HX2 | Cypress Semiconductor

Support & Community

Default TT Mode of HX2

Last Updated: June 15, 2011

Why is the TetraHub set-up to default to single TT when it can support multiple TT?


The TetraHub defaults to single TT because at the time of designing HX2 the 2.0 drivers (from Microsoft) were not able to support multiple TT hubs. In order to change the mode to multiple TT, the host must issue a SetInterface Request to the TetraHub. Note that the TeraHub has an option of 0xD2 Load where an external SPI EEPROM is used to set various fileds of the hub descriptor. You may use an EEPROM to set the hub to default to multiple TT mode on enumeration using this 0xD2 load. When the host determines that the hub can indeed support multiple TT, it will send the hub device a Set-Interface request, when the hub will be set to multiple TT Mode.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type