You are here

CY22395 S0 & S1 Signals | Cypress Semiconductor

Support & Community

CY22395 S0 & S1 Signals

Last Updated: December 05, 2011

When creating a *.jed file with CyClockRT, there seems to be no place in the GUI to set S0 and S1. How can these be set in the bitmap?


CyberClocks currently only allows for two table entries on PLL1. That means 000, 001, 010, and 011 are all set to the same VCO frequency and 100, 101, 110, and 111 are all set to the same value. If eight table entries are needed, the

CY22392 can be used.

Provide feedback on this article

Browse KB By Product

Browse KB by Type