Configuring pipelined vs. flow-through mode after power up | Cypress Semiconductor
Support & Community
Configuring pipelined vs. flow-through mode after power up
Can the Flowthrough/Pipeline mode be reconfigured after power-up for some Full flex dual port SRAM's?
The Flowthrough/Pipeline mode can be reconfigured after power-up. To do it safely, no other valid operation should be done during the *FT/PIPE change. It is recommended that you first disable the chip, then change *FT/PIPE pin (from VCC to GND or vice versa), then wait a cycle before resuming normal read and write operations.