You are here

Configuring the Device to use external memory | Cypress Semiconductor

Support & Community

Configuring the Device to use external memory

Last Updated: December 31, 2011

Why should the program be loaded into the external memory prior to starting the device, when the development board is configured to have low memory?


The 8051 splits memory into two types of memory, code and data memory.When the low memory is configured to be external memory it needs to have the program loaded into it prior to starting.

1. If you try to load via a B2 load from an EEPROM, the SIE loads the program to internal memory,(the SIE can only load to internal memory).

2. If you try to load via the ezloader function and a B0 load, the system still loads a small program to process the load.  This program ends up in the internal memory and again you cannot execute it.

The only way to use this is have the program in the external memory before the chip is taken out of reset. his is normally done with external non-volatile memory.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type