You are here

Configuration of FX2/FX2LP to GPIF Mode | Cypress Semiconductor

Support & Community

Configuration of FX2/FX2LP to GPIF Mode

Last Updated: April 04, 2011

How do I configure the FX2 to go into GPIF Mode?


To configure the pins for GPIF mode, the IFCFG[1:0] bits in the IFCONFIG register must be set to 10.
For more information about GPIF please read through the GPIF chapter in the FX2 Technical Reference Manual. In addition, please refer to the application note, EZ-USB® FX2LP™ GPIF Design Guide - AN66806.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type