You are here

Byte 7 of the EEPROM for a 0xD2 load. | Cypress Semiconductor

Support & Community

Byte 7 of the EEPROM for a 0xD2 load.

Last Updated: June 13, 2011

How is byte 7 of the EEPROM interpreted? What is the purpose of the Enable Overcurrent timer and Disable Overcurrent Timer? What is the difference between these two parameters and how are they used?


There are two different timers for the overcurrent condition, one for an enabled port and the other for a disabled port. Both these timers are used for making sure when an overcurrent condition occurs, the hub will report it after the time set in bits 0..3 (for disabled port) and bits 4..7 (for enabled port) of byte 7 of the EEPROM. The difference is that an enabled port might lose its configuration information if there is a power glitch, while a disabled port has no such problem. A disabled port will need a bus reset to make it enabled, and this reset should restore its operation. In essence, this is an extra filter for overcurrent conditions.


Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type