You are here

AT2LP setup time | Cypress Semiconductor

Support & Community

AT2LP setup time

Last Updated: April 04, 2011

How much time is necessary before the AT2LP can communicate with the ATAPI device once the power supply is turned on?


The time taken by the AT2LP to access the drive after reset is programmable and depends on an EEPROM byte setting. The Delay after Reset configuration at address 0x0D, determines the time taken. Default value of 0x00 would cause a delay of 1000ms before the AT2LP accesses the drive. Any other value would give corresponding increment as a multiple of 20ms.

More about the configuration setting can be obtained from the datasheet of AT2LP.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type