Applying Vdd and Vddq during QDRII/DDRII power up sequence | Cypress Semiconductor
Support & Community
Applying Vdd and Vddq during QDRII/DDRII power up sequence
The QDR datasheet recommends that during power up sequence to apply Vdd before Vddq. Is it mandatory during the power up sequence to apply Vdd before Vddq?
Response: It is recommended to apply Vdd before Vddq during QDRII/DDRII power up sequence. However, it is not a requirement to apply the Vdd before the Vddq for Cypress QDRII/DDRII devices and has been specified in the Cypress datasheets to accommodate the requirements of other vendors in the QDR consortium. Vdd and Vddq can be applied simultaneously during power up, as long as Vddq does not exceed Vdd by more than 0.5V during power-up.