Analog ground not getting connected at output pin. | Cypress

Support & Community

Analog ground not getting connected at output pin.

Last Updated: June 26, 2011
Question: 

Why can't I get Analog Ground at the output pin even if I configure TestMux for the same, though I get RefHi and RefLo at the output in PSoC1 ?

Answer: 

Only for routing AGND, the respective Analog Block needs to be powered. The block can be power by configuring bits 1 and 0 in ACBxxCR2 resistor. This is not a necessity for routing RefHi and RefLo at the output pin. You can also power the SC Blocks by making the The Analog Power setting as SC On / Ref x in Global Resources. If the power setting is SC Off / Ref x, all SC blocks will be turned off and the ADC will not work.

Provide feedback on this article

To protect your privacy, do not include contact information in your feedback.

Browse KB By Product

Browse KB by Type