You are here

Air Gap between Capsense Sensor and an Overlay | Cypress Semiconductor

Support & Community

Air Gap between Capsense Sensor and an Overlay

Last Updated: December 07, 2011

Can there be an air gap between a Capsense sensor and an Overlay?


Capsense is not recommended to have any air gap between Capactitve Sensor PCB and an Overlay material.

If the requirement demands an air gap, you may connect a spring between the capsense button and the overlay, this should enable to detect it as a button with better sensitivity.

You may also refer an application note "

Using Springs as CapSense Sensors AN44999"

This application note considers the possibility of using springs as sensors. A comparison with solid conductive sensors and recommendations for the practical usage of springs are also discussed.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type