You are here

Adhesive recommendations for CapSense overlays | Cypress Semiconductor

Support & Community

Adhesive recommendations for CapSense overlays

Last Updated: June 13, 2012

What kind of adhesive can be used for sticking overlay with the CapSense PCB? Are there any considerations while selecting the adhesive?



For CapSense applications, following are the basic two considerations while selecting an adhesive:

1. Since the dielectric constant of air is very low, an air gap between the overlay and sensor degrades the performance of the sensor. Thus, the adhesive should be used to properly stick the overlay with the PCB.

2. The adhesive must be nonconductive.

A transparent acrylic adhesive film from 3M™ called 200MP is qualified for use in CapSense applications. This special adhesive is dispensed from paper-backed tape rolls (3M™ product numbers 467MP and 468MP).


Refer "getting started with CapSense" design guide for CapSense design guidelines.

Knowledge Base Tags: 

Provide feedback on this article

Browse KB By Product

Browse KB by Type