are there any registers in the CYUSB3014 that can be used to retrieve an Unique-Id or something similar.
Thanks in advance, Thomas
I am also searching for the same. How am I doing now is, writing to a register by firmware and reading it back. For each device we need to build a new firmware. We can use SPI Flash to store some unique ID. Please some one guide about how to set a unique ID in Flash and Our firmware will read from the register. We should not build the firmware for each ID. ID should be writtened seperately using any SPI Write.
Gokul Prasath N
There will be a 66bits unique ID for each die of FX3. You can read these bits from the address location 0xE0055010.
Thank you for your fast reponse. This is really helpfull for us. Anyway, did you mean a 64Bit-UniqueId?
Sorry its a typo. It is a 64bit unique ID not 66bit.
Thanks for your reply. It is really helpful for us.
A small clarification.
The unique ID is actually stored in two registers each of 32 Bit.
Their address : 0xe0055010 and 0xe0055014.
- Madhu Sudhan
I cann't find the description of 0xE0055010 register in FX3 trm.
May be Cypress has another document with registers descriptions?
Yes. It is not available in TRM.
I took it from an internal document whose selected contents are only revealed.
Thanks for your reply.
Hello Madhu Sudhan!
Thank you for the reply.
Could you point where the information about die ID is descripted in the documentation?