Programming EEPROM failure on CYUSB3Kit-003 | Cypress Semiconductor
Programming EEPROM failure on CYUSB3Kit-003
I found some problem when programming my CYUSB3KIT-003's EEPROM. I followed document "CYUSB3KIT-003 SuperSpeed Explorer Kit User Guide(Doc. # 001-93186 Rev. *A)" to program my CYUSB3KIT-003. I use "USB control center " software to program the board.
I program EEPROM using menu Program->FX3->I2C EEPROM. After I select the SF_loopback.img file, it begins to program. At first, It seems to be right. However, USB control center says "Programming of I2C EEPROM failed" after about 15 seconds. (See attach below).
I have tried this in two different PCs and two CYUSB3KIT boards. I also tried to program the EEPROM using the following Jumpper settings:
1. J2-5 short
2. J2 J3 J5 short, J4 open
3. J3 short, J2 J4 J5 open
4. J3 J4 short, J2 J5 open
In all of my attemps, the USB control center says "Programming of I2C EEPROM failed" after about 15 seconds.
BTW: I made the above tests in both Windows7 32bit and Windows7 64bit. I'm going to try Linux.