I get driver cannot start code10 error when I install the FX3 SDK host driver. Is there any one met the same issue and fix it? Thanks any advise.
I had the same issue until I reset the device then all was good. The "!" should then get removed from the Device Driver list.
Thank you, cjc. It doesn't work when I reset the board.
In my PC, I added a USB3.0 adapt card since no USB3.0 comes with PC. The card uses ASMedia XHCI controller. When the FX3 board is connected to this USB3.0 port, the code 10 error is shown with Cypress USB BootLoader in device list. But when the FX3 board is connected to the USB2.0 port that comes with the PC, there is no error with Cypress USB BootLoader. Is it the ASMedia XHCI controller compatible to FX3 SDK? Any one has the USB3.0 adapt card compatibility issue with using FX3 SDK? Thank you.