You are here

CY7C68013A throughput in bulk mode | Cypress Semiconductor

CY7C68013A throughput in bulk mode

Summary: 2 Replies, Latest post by alex_ts on 28 May 2011 09:39 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
alex_ts's picture
2 posts


I am trying to measure the FX2LP USB chip througput in bulk mode. In order to do so, I have modified bulk example firmware so it continiously fills the two output endpoints (0x86, 0x88) with 512 data bytes. I have also changed the BulkLoop C# application to read the data from those two endpoints. I have measured the time between start and stop commands and the number of bytes I was able to read from the device in this time. My result was about 0.8 MBytes/s, but I was expecting much higher throughput.

I am using Win7-64. How can I verify that the system operates in high speed and not in fast speed (0.8MBytes/s seems like fast speed mode to me)? Is there another possible reason for such low speed?


Thanks, Alexey.

aasi's picture
Cypress Employee
1166 posts

I've seen speeds upto 40MBps. Use the streamer application and cystream firmware that come as part of SuiteUSB for the measurement.

The device would report its capability through descriptors, FX2LP would report USB2.0 support so if it is enumerated as full-speed you should see a pop-up with a message similar to device capable of operating at higher speeds you might want to switch the device to a high-speed capable port.



alex_ts's picture
2 posts

Thank you very much for the reply.

I have found out that the bottlenack was the embedded part - filling the endpoints. Removing the endpoints filling by the CPU and just submitting to USB (filled with junk) increased the throughput to 16MBytes/s which is quite good.


Thanks again.

Log in to post new comments.