You are here

cy7C68013 C0.C2 mode | Cypress Semiconductor

cy7C68013 C0.C2 mode

Summary: 1 Reply, Latest post by VAVC on 16 Jan 2014 12:24 AM PST
Verified Answers: 0
Last post
Log in to post new comments.
Bram's picture
2 posts

 i have write a  firmware, and use the kneil 4 to compile it, when output, i use the command as below:

Hex2bix.exe -i  -o bulktogpif.iic bulktogpif.hex -f 0xC2 -v 0x0451 -p 0x32AF

the i use the control center download it to EEPROM, and the software show it programmed successfully, and i also load 
the sprit file and display the sprit,
But, it seems that the usb is started as the C0 mode, 
can you help me, how can i know whether EEPROM is programming successfully and the 68013 is working by load the firmware which is written by myself?
VAVC's picture
Cypress Employee
506 posts

 Hi ,

Please share the .*iic file which you have used to program the EEPROM. you can read the contents of EEPROM by using some vendor commands. Refer vend_ax example avaialble in the path (C:\Cypress\USB\CY3684_EZ-USB_FX2LP_DVK\1.0\Firmware)after installing CY3684. Also refer the application note in the following link

if possible share the firmware also.




Log in to post new comments.