You are here

Reading data fails on the 16 Bit slave fifo interface | Cypress

Reading data fails on the 16 Bit slave fifo interface

Summary: 1 Reply, Latest post by Sil on 21 Oct 2011 08:22 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
Sil
Sil's picture
User
93 posts

Hi all,

I am trying to read data on the slave fifo interface. As can be seen on the first page of the attached pdf, the first read attempt succeeds and is stopped after flag A (empty/full fixed to thread 0) indicates fifo empty.

On the second page an example is shown, where data is read using two read accesses. The first access works good, while during the second access the data lines get stuck at 0x0000.At the same time flag A gets stuck high until I reset the FX3 chip. The clock frequency is only 10 MHz.

Any ideas?

 

Thanks

-Silvio

 

Attachments: 
Sil
Sil's picture
User
93 posts

If I configure tread selection fixed on Thread0 instead of "adress driven on interface" (with the GPIF II designer), it is working. I doublechecked the wiring for the adress lines and found it error free. Nobody out there who encounters similar issues? Thanks.

-Silvio

Log in to post new comments.