programming of I2C EEPROM AT24C1024B failed - while using control center | Cypress Semiconductor
programming of I2C EEPROM AT24C1024B failed - while using control center
I am using the FX3 DVK board with atmel's i2c eeprom AT24C1024B. I am using control centre to program the eeprom. My switch SW40 is off, on,on,off. all jumpers are correctly placed.
However when I try to load the USBBulkLoopAuto .img file I always get the error message : programming the I2C EEPROM failed.
I have followed everything that is there in the documents and still I have the same problem.
This is the first time I am using this board and I was not able follow the elf2img thread. I need help with programming the EEPROM.
Should I change anything in the USBBulkLoopAuto example before I generate the .img file?
Should I change any other connections or any other information?