You are here

How to add vendor commands? | Cypress Semiconductor

How to add vendor commands?

Summary: 1 Reply, Latest post by RASH on 13 Jan 2016 04:48 AM PST
Verified Answers: 0
Last post
Log in to post new comments.
Hyunwoo Song's picture
1 post

I'm trying to configure fpga using fx3 connected between Mobile Device and FPGA board.

And I am doing that by refering to the Manual "Configuring an FPGA Over USB using Cypress EZ-USB FX3".

By looking at "Integrating the Configuration Firmware Into Your Design" in the manual, it says "Add the support for vendor commands and events as they are implemented in this example", and I don't understand what it means.

How to add the supports for vendor commands in my design?

RASH's picture
Cypress Employee
22 posts

Host application for configuring the FPGA will interact with the device with USB requests and events. Refer to CyFxSlFifoApplnUSBSetupCB() where we are handling set of vendor commands(CY_U3P_USB_VENDOR_RQT) and setting some events.


Log in to post new comments.