You are here

FX3 Many to one setup | Cypress Semiconductor

FX3 Many to one setup

Summary: 1 Reply, Latest post by Madhu Sudhan on 06 Jul 2015 04:01 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
Loffa's picture
1 post



I have some troubles setting up the FX3 in a many to one configuration.

I downloaded the Example-project for the firmware from this website. It was called "GPIF_Example2" .

Trying to read data with the Streamer program show that all packeges are failed.

I did not change the code anywhere before trying it out on the board. Is this a known problem or is it something that I can fix?




mady's picture
Cypress Employee
963 posts


Did you keep the !WR signal Low? (I.e GPIO 17 (CTL0) pin which is !WR should be connected tpo ground for this project to work.


- Madhu Sudhan

Log in to post new comments.