Control center transfer file out problem | Cypress Semiconductor
Control center transfer file out problem
I am presently using cypress sdk 1.2.3.
I am trying to program a slave fifo sync firmware with a FPGA.
I am observing my flags on my oscilloscope.
1st Problem: with cypress control center, when I try to transfer a file out using cypress control center.
I can see that bulk out transfer successful but no flag changes.
2nd problem. when I send data using Tranfer data out in control center we normally generate only zeroes. and I can see the zeroes recieved correctly in my FPGA. But when I send some hexadecimal (Data to send(Hex)). I recieve in FPGA only 0xFFFFFFFF all the time..(FLAGS WORK PROPERLY IN THIS CASE WHEN DATA TRANSFER OUT IS USED)
What might be the problem.