You are here

Bus Power Correlates to transfer speed | Cypress Semiconductor

Bus Power Correlates to transfer speed

Summary: 2 Replies, Latest post by refael.s_1664056 on 14 Nov 2016 09:27 AM PST
Verified Answers: 0
Last post
Log in to post new comments.
refael.s_1664056's picture
User
3 posts

We are using Cypress FX3 device in our system, hooked in a self power configuration.

While making some testing on performance speed using an Ubuntu system, we are seeing some degradation with respect to a Windows based PC.

Changing power method from self-powered to bus-powered, there seems to be a slight improvement to performance on SS speeds.

Now, I have two questions:

1. Is there any correlation between power method and FX3 speed?

2. Are there any special notes when using Ubuntu, and more specifically an embedded version of it?

Refael.

nisa's picture
Cypress Employee
86 posts

Does the host on Ubuntu able to provide the required power? Can you measure the current/power that the host is suplying and compare it with the power consumed in the self powered mode? This can give more idea on this behaviour. How much is the difference in throughput is observed?  As such, there is not relation of speed and the power mode if the host is capable enough to provide whatever the device requires. 

For the device-FX3 it does not know if the host is Windows or Ubuntu. So, there is no change on the device side, we just need to check the host side limitation if any due to OS. What are the data rates you observe ? What is your applicaiton  ? Is it bulk or Isoc transfers?  We have seen slightly lower data rates on Linux PCs, we have tabulated our test results in one application note. The document mentions our findings on different OS, mode -Bulk/Isoc with different burst. Please compare your test result with the one in this applicaiton note AN86947:

http://www.cypress.com/documentation/application-notes/an86947-optimizin...

refael.s_1664056's picture
User
3 posts

I am unable to measure the current supplied by the host, as there are no testing points for it in my current design.
Data rates seen by FX3 device on a Windows based PC are ~80MB/s.
Data rates seen by FX3 device on a LINUX Embedded device are ~20MB/s.

My application basically is a frame grabber downloading an image in the size of 2MB, in bulk transfer mode (upon your reply here we are attempting a test for Isoc transfer mode - will communicate results once we have them).

Are there any special notes when using an Embedded system as my host (running a custom version of UBUNTU running kernel 4.4.19 with an ARMv7 architecture)
 

Log in to post new comments.