You are here

Orcad Symbol for QDR-II SRAM CY7C2663KV18-450BZI and adress pin clarification | Cypress Semiconductor

Orcad Symbol for QDR-II SRAM CY7C2663KV18-450BZI and adress pin clarification

Summary: 1 Reply, Latest post by Krishna GSNS on 22 Nov 2016 09:43 PM PST
Verified Answers: 0
Last post
Log in to post new comments.
abhishek_1475941's picture
User
1 post

Is there Orcad Symbol available for CY7C2663KV18-450BZI.

Also I read in the forum that address pins can be assigned in any order as per the document in the post below.

http://www.cypress.com/file/56341/download

But this document also talks about the special case where A0 and A1 must be in the same location on both SRAMs. This case occurs when the application is using the internal Burst Counters.

This is not applicable for CY7C2663KV18-450BZI RAM I hope as there is no A0/A1 pin marking on the ball out.

Please confirm.

Regards,

Abishek

Krishna GSNS's picture
Cypress Employee
48 posts

Hi Abhishek,

Regarding the address pins please refer the KB article from the link given below:

http://www.cypress.com/knowledge-base-article/address-pins-burst-4-mode-...

ORCAD symbol is not readily available.

Thanks.

 

 

Log in to post new comments.