Any problems in posting your question?
no, not at all. actually it was an network problem. but thanks for response, hope you'll continue the same in future.
need some help in programming the capsense PSoC CY8C20534, if you have any samples for the same please convey.
Thread continues here ... www.cypress.com/
thanks Bob, hope we'll have good options for each other.
hey, Bob I tried working my board with the code I have; its working ok for the buttons-- they are glowing the LED's accordingly.
Now the problem I'm facing is slider.
I'm using the separate LED's for each sensor in the slider. I'm unable to program any of those. the syntax I'm using is as--
void display_update_LEDs(BYTE sensor_state)
LED_0_Switch( (sensor_state & 0x02) ); ----------B0==L0
LED_1_Switch( (sensor_state & 0x04) ); ----------B1==L1
LED_2_Switch( (sensor_state & 0x08) ); ----------B2==L2
LED_3_Switch( (sensor_state & 0x10) ); --------- B3==L3----------till here my 4 buttons are working ok
LED_4_Switch( (sensor_state & 0x01) ); --------- B4==L4------------this one is used as a pre-requisite for the slider
i.e. it has to be ON to turn ON the slider sensors.
the condition for the slider is B4+(any of the slider sensor) will be ON a/c ly.
LED_5_Switch( (sensor_state & 0x??) ); ----------here after slider sensors start-------B5==L5
LED_6_Switch( (sensor_state & 0x??) ); ---------- B6==L6
LED_7_Switch( (sensor_state & 0x??) ); ---------- B7==L7(to be done)
LED_8_Switch( (sensor_state & 0x??) ); ---------- B8==L8
can you tell me the values in the '??' block and logic behind it.
I'm afraid you will have to post your complete project here to answer your question. Use Designer -> File -> Archive Project and then attach the resulting .zip file.
can you give me the sample program for the buttons and slider with separate LED's for each sensor?
Yes, of course, but you may do that yourself.
Open Creator 3.0 and select on the start page "Find Example Project". There are some examples using CapSense CDC which you can adapt to your chip and the board you use easily. Together with the example usually comes a detailled documentation which may additionally help you.
Oh, I am very sorry, my advices were for PSoC3/4/5 and you are using PSoC1 for which I do not have got an example yet.
From this page here you can find example projects for the listed kits, something will be there for you:www.cypress.com/
Hi Bob, can you tell me what actually is the INTEGRATING INPUT-----I/O P0 of CY8C20534 28-Pin (SSOP)