UDB Editor Example Project | Cypress Semiconductor
UDB Editor Example Project
Well that's it, had seen the UDB editor videos, and give it a try, so i find the UDB Editor info on Creator, at the end of the document is does a Step-By-Step project that takes a number, shift it twice to the left (aka multiply by 4) and add 127 to it, "very easy" i say.
Did the Step-By-Step, and replace the LCD with an UART component to get the result of the operation, i feed the component with a decimal '10' value, i got a result of 0x28 (40) instead of 0xA7 (147) as expected, so i was not even able to make a Step-By-Step project run properly, by the result i guess the problem is on the add 127 instruction. Tried to fix the problem but i follow all the steps properly (i guess), i can't see the error, maybe one of you can see it.
Project is attached, i got it running on the 5LP Prototyping Kit, but it must run on any PSoC device.
Thanks in advance