You are here

Support: PSoc Creator 4.1 dropped support for Cy_Pin 2.5. | Cypress Semiconductor

Support: PSoc Creator 4.1 dropped support for Cy_Pin 2.5.

Summary: 4 Replies, Latest post by wsm on 18 Jul 2017 07:19 AM PDT
Verified Answers: 1
Last post
Log in to post new comments.
wsm
wsm's picture
User
109 posts

 

  PSoc Creator 4.1 ships without Digital Output Pin version 2.5.  This was available in PSOC Creator 3.0 and 4.0.  This causes designs loaded into 4.1 to fail.

 

I tried filing a case, but it was closed immediately.  An email said I had to go to the support community, but the "support" link in the community page points back to the mycases which get canceled and an email is generated telling you to go to the support community to file a case which gets canceled and causes an email to be sent which tells you to......

 

 

user_1377889's picture
User
10705 posts

So why don't you update all the components of your project to latest?

 

Bob

wsm
wsm's picture
User
109 posts

Ah, you haven't transitioned between PSOC Creator versions lately using the latest versions of stuff.

v2.5 is the latest for the pin.  I had to backdate to v2.2 of the pin using creator 4.0, then move back to 4.1.  I believe this to be an oversight on the part of the packagers.

One problem was 4.1 did not give me the opportunity to "update to the latest," as it has in the past, it just ripped out the pin and put it into a square, with no notification of where it was connected.  Very disturbing.

 

 

user_1377889's picture
User
10705 posts

I frequently open projects from forum visitors with outdated components. Up to now a component update has always cured these issues. Only exception so far were self-made components which had to be updated first (before updating the project)

 

Bob

wsm
wsm's picture
User
109 posts

That has also been my experience in the past.

 

Log in to post new comments.