Simple bus and pins question | Cypress Semiconductor
Simple bus and pins question
I should know how to do this, but for some reason I have a mental block.
I have a very basic project, with two digital input pins and a debouncer.
The pins component is set to have 2 pins.
The debouncer is set to a signal width of 2.
The Pins component shows 2 separate connections for the pins. 0 and 1.
The debouncer input shows as a bus d[1:0]
The question is, how do I connect the 2 pins to the debouncer inputs?
If I draw a wire out from the debouncer inputs it correctly shows as being a bus with indexes from 1 to 0.
If I draw a wire out from one of the pins is correctly shows as a wire. (Width is 1).
When I try to connect the wire to the bus it immediately changes back to being a single wire.
I just can't remember how to connect a wire to a specific index in the bus.
My really basic project is attached.