You are here

General Questions on PSoC Creator and First Touch Starter Kit | Cypress Semiconductor

General Questions on PSoC Creator and First Touch Starter Kit

Summary: 1 Reply, Latest post by JimmyD on 19 Mar 2010 12:45 PM PDT
Verified Answers: 0
Last post
Log in to post new comments.
davemullenix's picture
6 posts

Rather than ask thirty different questions in thirty different Topics, I thought I'd ask them one at a time in a single thread.

I have about a lot of electronic experience and I've played a little with microprocessors, but the PSoC is new to me and the more I play with mine, the more questions I have.

FIRST QUESTION: Is it possible to save a Component Block? For example, in the CapSense Slider project that comes with the First Touch kit, the schematic shows an 8 bit control register connected to an 8 bit inverter through a bus and the inverters drive the 8 LEDs. All of these parts are inside a rectangle labeled Component Block for LED Control.

I'd sure love to copy that block, save it somewhere and just plunk it down into any future design that uses LEDs. Is this possible and if so, how do you do it?

jfmd's picture
Cypress Employee
21 posts

This is definitely possible. Check out the PSoC Creator 110 training (and the add'l modules there) to see how.



Log in to post new comments.