You are here

Embedded Trace Macrocell (ETM) in PSoC Creator | Cypress Semiconductor

Embedded Trace Macrocell (ETM) in PSoC Creator

Summary: 1 Reply, Latest post by Carlos on 04 Jun 2016 09:46 PM PDT
Verified Answers: 1
Last post
Log in to post new comments.
cody_1672391's picture
1 post

I've recently received a PSoC 5LP dev kit, and I've found the Creator software very impressive so far! However, I've been looking into debugging options that would hopefully avoid a dependence on a UART module. I came across but this doesn't seem to provide much help for those without access to IAR or Keil IDEs.

Is there any documentation detailing how to configure this sort of capture and analysis in Eclipse, or specifically in gdb? Or even better, is there any planned timeline for adding these features to PSoC Creator?

user_365962704's picture
143 posts

I used a Logic Analyzer to get the ITM "printf" from a pin (i think is SDO), and used Sigrok to decode it:

Not the solution you want but maybe it can help.



Log in to post new comments.