You are here

Creator gets stuck while building project | Cypress Semiconductor

Creator gets stuck while building project

Summary: 4 Replies, Latest post by otgonz on 19 Feb 2016 03:29 AM PST
Verified Answers: 2
Last post
Log in to post new comments.
otgonz's picture
4 posts

Hi, I need help with Psoc Creator. I have a CY8C5888LTI-LP097 evaluation board. The project I'm working have two Glitch Filters. When I try to build the project using the glitch length samples set to 2, the build is successful. But if I change the glitch length samples to 9, the build gets stuck in the "Synthesis" step. I have tested both 3.1 and 3.3 versions of Psoc Creator and Windows 7. How can I fix this issue?



user_1377889's picture
9301 posts

Welcome in the forum, Otniel

I would suggest you to get in contact with Cypress directly. At top of this page Design support -> Create a Support Case. You will get a reply shortly. Consider attaching a workspace archive to the case (Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.)




otgonz's picture
4 posts

Thanks! I'll do as you say.

jobi's picture
Cypress Employee
69 posts


Posting the resolution from the case:
The issue is due to the availability of resources.
In datasheet, resource requirement for glitch filter is: 

1. N - Signal width; L - Filtering length

The corresponding project is having signal width greater than 8

Thanks and Regards


otgonz's picture
4 posts

Thanks for the explanation.  I modified the design so there is enough resources now.  But in fact, there is an issue with the compiler, as the Technical Support told me.  The compiler should give the results in a couple of minutes, either successful or fail.  The compiling time of my design was more than three hours.  They will check this issue with the program.

Log in to post new comments.