You are here

Creator Enhancement | Cypress Semiconductor

Creator Enhancement

Summary: 3 Replies, Latest post by Weil on 18 Aug 2014 11:45 AM PDT
Verified Answers: 0
Last post
Log in to post new comments.
user_14586677's picture
7646 posts

It would be welcome when Creator uses a module that requires

assigned pins, like LCD, that the tool, or datasheet, defines what

settings are used on the pins. In order to see this now one looks

into auto generated code, usually the Start(), and wades thru code

trying to figure out how the pins were set up. It cannot be seen in pin

view in *.cydwr tab.


I think I2C also another example of this problem.


Project datasheet like created in PSOC Designer ?


Regards, Dana.

user_1377889's picture
9281 posts

I can support that request and extend the requirements:

A customer had to review a board that led into a re-assigning of two pins. Since both versions of the pcb where out in the field the updating became a bit tough although the PSoC "knew" on which board it was seated (versioning). Something like a "Dynamic Associated Pin" like in the Software Transmit UART could have helped him out.

Using different development kits all the time and pcb's in a prototype stage with LEDs and switches on different pins doesn't make life easy. I would be glad about some help to build a dependancy between a pin-assignment and a project source.



user_14586677's picture
7646 posts

Actually a further request is that a sortable "view" of pins in table form where all key

pin parameters listed for each pin.


Regards, Dana.

rbyn's picture
Cypress Employee
92 posts

I've passed the feedback onto the development team. 


Log in to post new comments.