You are here

Character LCD with I2C Interface Component | Cypress Semiconductor

Character LCD with I2C Interface Component

Summary: 8 Replies, Latest post by Ron on 23 Sep 2016 01:43 PM PDT
Verified Answers: 1
Last post
Log in to post new comments.
Ron
user_352784942's picture
User
99 posts

Hello,

This is a bit of a one off,  but I'm curious to know if someone has been successful with adapting (configuring) the Character LCD with I2C Interface component for use with a 1602 display module such as this (http://www.ebay.com/itm/Display-IIC-I2C-TWI-SP-I-Serial-Interface-1602-1...

They are inexpensive and I plan to use them in a new amateur radio transceiver based on the PSoC 5.   

If this is not the proper forum for this post, please convey an alternate forum.

Regards,

Ron

user_242978793's picture
User
1200 posts

The 1602 is a normal display and will work with the PSoC HD44780 Controller components .  Here is a program that should work.

Ron
user_352784942's picture
User
99 posts

Thanks, I will take a look.

Ron
user_352784942's picture
User
99 posts

I have built the project but have a question.  Where is the schematic component located so that I may place it on the top design?

user_242978793's picture
User
1200 posts

This a library you add the library to your library location then open a new project and add the library to your project using dependencies and you are ready to select the component. There is a schematic in the PDF of the library.

user_242978793's picture
User
1200 posts

This is a parallel model picture and it shows how to wire the LCD module you will only have 2 digital wires but you will need the other lines.

Ron
user_352784942's picture
User
99 posts

Hello,

I think I did not phase the question correctly.  Where is the component that is to dragged on to the top design schematic page?

Ron
user_352784942's picture
User
99 posts

OK, Now I see.   Thank you.   I added the dependencies to the project and the component is now available.

Thanks again.

Ron
user_352784942's picture
User
99 posts

It is now working.  Thanks!

Log in to post new comments.