Bootloader using USBUART Doesn't Work | Cypress Semiconductor
Bootloader using USBUART Doesn't Work
I want use the USBUART and Bootloadable modules together. Using both modules as their default settings I select USBUART as the Communication component in the Bootloader General tab. I then select OK and build. I get the following message:
"The selected Bootloader IO component is not correctly configured for use with the Bootloader. ..." It then goes on to say it must use EP1 OUT INT and EP2 IN INT. But changing the USBUART endpoints to match this makes the CDC drivers not load on the Host.
Has anyone got this working or does it just not work with the USBUART?
For those who wonder why I don't use USB HID (which does work), I'm using the USBUART in the bootloadable project and want to use the same USB interface for firmware uploading as well so that 2 sets of drivers do not need to be installed for my device.
PSoC Creator 3.3 with PSoC5 CY8C5888LTI-LP097