You are here

select debug target menu is empty | Cypress

select debug target menu is empty

Summary: 1 Reply, Latest post by Roy Liu on 16 Jun 2011 07:55 PM PDT
Verified Answers: 0
Last post
Log in to post new comments.
spidermyst's picture
User
3 posts

  Greetings,

I have a CY8CKIT-014 Psoc 5 First Touch starter Kit and a CY8CKIT-001 PSOC development kit. I have installed the necessary drivers and program on my computer but I cannot program the Psocs as the "Select Debug Target.." menu  is constantly empty. I have first installed the drivers from the CDs, but also from the website to make sure they were up to date.

 

I saw another post on this problem but the fix suggested did not work for me. I made sure the psoc was on before plugging in the miniprog3, and the problem is also there for the smaller Psoc 5 from the starter Kit (which does not require the miniprog3). I have reinstalled the drivers and programs several times now and restarted my computer too. My computer runs under Windows 7-64 bits.

 

Also, I checked in device manager and my computer recoginize both the small Psoc and miniprog3.

 

Would you  have any suggestions?

 

Thank you very much,

 

Timothee

yliu's picture
Cypress Employee
34 posts

Hello,

Does PSoC Programmer even can't see the MiniProg3 Pluged in as below?

 Regards,

Roy

Log in to post new comments.